Our jacking devices are used to align waterwall panels or plates and beams. There are currently 2 sizes of Panel Jacks available.
The small one is preferred for about 90% of all tube panel membrane fit up, and is designed for use with an (Enerpac RC-102 or OTC C-102C) cylinder. (Cylinders are not supplied)
The large one is preferred where membrane fit up needs a longer jack as on some Supercritical Boilers and is used with an (Enerpac RC-104 or OTC C-104C) cylinder.
They both have the same amount of jacking force and have been tested at the full capacity of the Porta Power cylinder (10 Tons).
When ordering weld on lugs for the Panel Jacks, please specify whether the jacks will be used for plates/beams or waterwall tubes, the OD of the tubing & membrane width is needed for the proper lug length. These 2 or 4 hole lugs can be reused many times.